Manual for Chaton rivets the screw press with vaccum pump
|
Manual as a PDF |
|
 |
A = Chaton Rivet screw press
B = Rivet fastener for SS18 Chaton Rivets
C = Ambos for 2mm back part
D = Chaton Rivet spin magazine for all Rivet sizes
E = Fitting board
F = Ambos star template to convert the Chaton Rivets without a back part
G = Rivet fastener for SS29 Chaton Rivets with 4mm Shank
H = Ambos for 4mm back part
I = Vacuum pump with silicone tube |
 |
Depending on the size, either SS18 (B) or SS29 (G), the rivet fastener is getting screwed on.
The suitable Ambos (for the 2mm or 4mm back part (C/H)) have to be fit in below. With the star template (F)you can convert the Chaton Rivets without a back part. Thereby the ending of the Chaton Rivets are getting radiating bended (S). |
 |
With the help of the worktop (D) you can pick up single Chaton-Rivets. Therefore you fit in the Chaton-Rivets into the worktop and direct it under the Rivet fastener. With a switch on vacuum pump you can pick up the Chaton-Rivets. |
 |
The back plates are getting put on the Ambos with the rolled side up. |
 |
You now put the item you would like to garnish on top of the Ambos. The rivet fastener with the Chaton-Rivet is getting pressed on the Ambos by pulling the lever (please make a little hole at firm materials such as leathers before use). |
|